Tycon-power RPDC12-9-10 Bedienungsanleitung PDF herunterladen

RPDC12-9-xx

RemotePro™ Remote

Power System

▫ Wireless Base Stations

and Client Devices

▫ Surveillance Cameras

▫ Remote Sensors

▫ Remote Lighting

▫ Off Grid Electronics

Congratulations! on your purchase of the RemotePro™ off-

grid remote power system. Please take a moment to review this

Qwik Install Guide before assembly or battery installation.

DANGER! Avoid Powerlines!

You Can Be Killed!

When following the instructions in this guide take extreme care

to avoid contact with overhead power lines, lights and power circuits.

Contact with power lines, lights or power circuits may be fatal. We rec-

ommend to install no closer than 20 feet to any power lines.

Safety: For your own protection, follow these safety rules.

▫ Perform as many functions as possible on the ground

▫ Do not attempt to install on a rainy, windy or snowy day or if

there is ice or snow accumulation at the install site or if the

site is wet.

▫ Make sure there are no people, pets, etc. below when you are

working on a roof or ladder.

Recommended Tools: Phillips Screwdriver, 3mm Allen

Wrench, 8mm and 14mm Open End Wrench

Please help preserve the environment and return

used batteries to an authorized depot

1 2 3 4

RPDC12-9-xx RemotePro™ Remote Power System ▫ Wireless Base Stations and Client Devices ▫ Surveillance Cameras ▫ Remote Sensors ▫ Remote Lightin

2 Qwik Install STEP 0: Mount the solar panel to the bracket and to the pole. It’s best to mount so that the solar panel shades the enclosure. STEP 1

3 STEP 7: Tighten the RJ45 Feedthru on the cable. If the cable diam-eter is too small to make a good seal, wrap a couple turns of electrical tape aro

4 8000015 Rev 2 RPDC RemotePro™ Qwik Install Guide SPECIFICATIONS Subject to change without notice Continuous Power Rating 1.25W or

Keine Kommentare

Tycon-power RPDC12-9-10 Bedienungsanleitung